HP Dx5150 - Compaq Business Desktop Reference Manual page 114

Removal and Replacement Procedures— Small Form Factor (SFF) Chassis
6. Press and hold the drive release latch 1.
7. Slide the drive to the right of the bay 2, then pull the drive from the bay 3.
To replace the hard drive, reverse the above procedure.
✎
When replacing the hard drive, transfer the four screws from the old drive to the new one. The
screws take the place of drive rails. You will need a Torx T-15 screwdriver to remove and
re-install the guide screws.
Make sure you route the drive cables properly
rotating the drive cage to its original position.
7–20
(Section 7.8.2, "Cable
361685-001 Service Reference Guide, dx5150
Management") before