Cary Audio Design SLP-98 Operating Manual

Cary Audio Design SLP-98 Operating Manual

Hide thumbs Also See for SLP-98:

Advertisement

Quick Links

SLP-98
OPERATING MANUAL
NOTE:
Before installing your new SLP-98, please read this manual carefully as it will
inform you of the SLP-98's specifications, proper installation and operation
procedures. Also included in this manual are guidelines on how to properly
service and care for your new SLP-98.

Advertisement

Table of Contents
loading

Summary of Contents for Cary Audio Design SLP-98

  • Page 1 SLP-98 OPERATING MANUAL NOTE: Before installing your new SLP-98, please read this manual carefully as it will inform you of the SLP-98’s specifications, proper installation and operation procedures. Also included in this manual are guidelines on how to properly service and care for your new SLP-98.
  • Page 2: Specifications

    SPECIFICATIONS When the following cautionary terms are used in this manual, these definitions apply: WARNING: Electrical hazard! Misuse or failure to follow instructions properly may result in personal injury or death! CAUTION: No risk or personal injury; however, misuse or failure to follow instructions may result in damage to equipment.
  • Page 3: Power Supply

    2-6SN7 line stage 2-12AX7 (ECC83) phono section 2-12AU7 (ECC82) phono section output buffer POWER SUPPLY: Full wave rectification, center-tapped, pi-network featuring a filter choke. AC POWER REQUIREMENTS: 100-130 volts AC / 50-60Hz at 50 watts 200-245 volts AC / 50-60Hz at 50 watts WIRE: EE Teflon Silver WARM-UP TIME:...
  • Page 4: Dual Outputs

    AUX.-CD-TUNER-TAPE: These are line level inputs requiring flat frequency response GND: Ground lug for turntable chassis MONITOR: For use with tape recorders that employ a third head to monitor a tape as it is being recorded (may be used as a flat frequency response line input) TAPE OUT: Constant output of selected input signal for recording independent...
  • Page 5: Operation

    If you were the original purchaser of this unit and you purchased it in the United States, you should fill out the enclosed warranty registration card and return it to Cary Audio Design within 10 days of your purchase. Cary Audio Design also suggests that you keep your original packing cartons in case you need to ship the unit.
  • Page 6: Care And Service

    4.1 Tube Replacement If it becomes necessary to replace the tubes in the preamp the same brand should be used. A new tube kit is available from Cary Audio Design. Although tube life varies depending on the nature and degree...
  • Page 7 Non-Warranty Repairs Cary Audio Design will provide repair service for its products charging on a time and expense basis for the repairs. WARNINGS...
  • Page 8 PROPRIETARY RIGHTS: Cary Audio Design has proprietary right in the design and components of its units. While the purchaser is entitled to use the unit for its intended purpose, use of the unit for its intended purpose, use of the unit for copying, imitation, or reverse engineering is a violation...

Table of Contents