Using The A-B Repeat Function - Zoom Handy recorder H2 Operation Manual

Convenient Playback Functions
Using the A-B repeat
function
The A-B repeat function lets you specify two
points (A and B) in a file (or file pair for 4-
channel mode) and automatically repeat the
section between these points. To use this
function, proceed as follows.
NOTE
The settings described here cannot be made
while the recorder is operating. Stop recording
or playback before carrying out these steps.
1.
Bring up the main menu screen.
At the stereo mode or 4-channel mode top
screen, press the 4 (MENU) key.
2.
Bring up the A-B REPEAT
screen.
Repeatedly press the 3 (REW)/2 (FF)
keys to move the cursor to "A-B REPEAT"
and press the 5 (REC) key.
The screen for specifying point A appears.
3.
Specify point A.
Use the 3 (REW)/2 (FF) keys to move the
counter to the point where you want the
repeated section to start (point A). Then press
the 5 (REC) key.
The screen for specifying point B appears.
46
4.
Specify point B.
Using the 3 (REW)/2 (FF) keys to move
the counter to the point where you want the
repeated section to end (point B). Then press
the 5 (REC) key.
HINT
• The A/B point setting can be made also
while in playback mode.
• You can also set point B at an earlier
location than point A. In that case, the
section from B to A is repeated.
5.
Perform repeat playback.
When the A/B points have been set, press the
1 (PLAY/PAUSE) key. The section A → B
(or B → A) is played back repeatedly.
6.
Cancel repeat playback.
When you press the 5 (REC) key once more,
repeat playback is canceled and the A/B point
settings are cleared.
7.
Return to the top screen.
Repeatedly press the 4 (MENU) key until
the top screen appears again.
ZOOM H2