SIDE
FAULT FINDING - INTERPRETATION OF FAULTS
DF009
present
CONT
CC.1 - CC.0
Lock the computer using the fault finding tool command.
The XRBAG must be used for insulation measurements appropriate to the type of fault at point C1 (seat
connector) on the passenger's side air bag module line.
Is the value obtained correct?
YES
Check the connections on the seat connector (point C1).
Visually check the seat wiring. Reconnect point point C1.
Disconnect the computer connector and fit the 50 track B50 adaptor.
The XRBAG must be used to measure the insulation appropriate to the type of fault
on adaptor cable F .
If the value is not correct, check the connections on the 50 track connector (tracks 18
and 19) and replace the wiring if necessary
NO
Check the connections on the seat connector.
Replace the wiring between points C1 and C3 (seat wiring).
AFTER REPAIR
Air bags and seat belt pretensioners
None
NOTES
Reconnect the computer and the passenger's side air bag ignition module, then
switch on the ignition. Erase the computer memory then switch off the
ignition.Carry out a check using the fault finding tool and, in the absence of a
fault, unlock the computer . Destroy the side air bag module if there has been a
replacement (tool Elé. 1287).
WIRING
88-61
88
1AB8651.0
Need help?
Do you have a question about the Clio and is the answer not in the manual?