Bryant GAPAB Installation Instructions Manual page 5

WARNING
!
ELECTRICAL SHOCK HAZARD
Failure to follow this warning could result in personal
injury or death.
Before installing or servicing system, always turn off main
power to system. There may be more than 1 disconnect
switch.
CAUTION
!
EQUIPMENT DAMAGE HAZARD
Failure to follow this caution may result in equipment
damage or improper operation.
This unit cannot be powered directly from blower motor
leads. Voltages can exceed 190 VAC (120v motors). Do not
wire directly to blower motor. Wiring to blower motor will
damage power supply and void warranty.
AIR PURIFIER
POWER CORD
CABLE CONNECTOR
TO SECURE POWER CORD
TO FAN COIL CABINET
FUSED POWER CONNECTOR LEADS
FROM INSTALLATION COMPONENTS
(IN BAG ATTACHED TO POWER CORD)
GROUND:
ATTACH TO FAN COIL
GROUND (CHASSIS)
Fig. 10 - - Fan Coil Chassis Ground
Air Flow Sensor
1) Slide flow sensor tabs into support bracket
Fig. 11 - - Flow Sensor Install
NOTICE
AIR FLOW SENSOR CABLE OR AIR FLOW SENSOR
BYPASS PLUG MUST BE CONNECTED TO THE
POWER SUPPLY IN ORDER TO ACTIVATE THE AIR
PURIFIER
Fig. 9 - - Airflow Sensor Bypass Plug Installed
TO FAN COIL FIELD POWER CONNECTION
5 AMP IN-LINE FUSES
TO FAN COIL FIELD POWER CONNECTION
2) Rotate flow sensor and clip into bracket
5
A06670
TO L2 FIELD POWER SUPPLY
TO L1 FIELD POWER SUPPLY
A06515
A06412