Loading Data - Fostex FD-4 Supplement Owner's Manual

FD-4 Ownerís Manual Supplement
<Memo>
If program data to be saved is larger than the space available on one backup disk, the FD-4 tells you how many backup
disks are required when you select a Program in Step 6 of the ìSaving Dataî procedure in the previous page.
ABS
When you set the first disk, the save operation starts. When the disk is full, the FD-4 automatically ejects the disk and
displays [Ins. Disk 2], meaning ìPlease insert the second disk.î
Insert the second disk to continue the save operation.
Note: Mark the disks so that you can identify the order of the disks and you will be able to insert the disks
in the correct order to perform the load operation.

Loading data

* You can load data using the ìLoad PGM ?î menu in SETUP
mode. The following procedures assume that the backup disk
has been inserted into the backup SCSI drive, and a format-
ted disk has been inserted into the current SCSI drive.
< [Load PGM ?] menu>
* Input signal options: [dAT], [SCSi id-6]
* Program options: P01 - P99 (an individual Program)
* Track options
DAT: track 1 - 4, track 1 - 6
SCSI disk: All tracks will be automatically selected.
1. Press the SETUP key to enter SETUP mode, then
use the JOG dial to select [Load PGM ?] menu.
2. Press the EXECUTE/YES key.
[Device ?] appears, [DIGITAL] lights up, and the selected
input signal option flashes. ([dAT] flashes.)
Flashing
6
44.1kHz
(e.g.)
Two backup disks are
SYNC OUT DRIVE required.
CLK SCSI
AUTO A.PUNCH
44.1kHz
Flashing
SETUP
SYNC OUT DRIVE
CLK SCSI
AUTO A.PUNCH
Lights up
44.1kHz
DIGITAL
SETUP
SYNC OUT DRIVE
CLK SCSI
AUTO A.PUNCH
ABS
SYNC OUT
CLK
AUTO
3. Turn the JOG dial to select a flashing [SCSi id-6]
to load data from the connected SCSI disk.
Flashing
4. Press the EXECUTE/YES key.
The saved backup number (B01) flashes. This means that
B01 on the backup disk is selected to load.
If only this backup file exists on the disk, turning the JOG
dial will allow you to select [B01] or [Eject].
Select [Eject] if you wish to change the disk.
If there are multiple backup files on the disk, using the
JOG dial allows you to select the desired backup data (B01,
B02, B03, etc.) or [Eject].
Flashing
ABS
5. Press the EXECUTE/YES key.
The FD-4 indicates that the load destination disk (current
drive disk) does not have any data, then indicates a flash-
ing [SURE?].
44.1kHz
(e.g.)
Three backup disks are
DRIVE
required.
SCSI
A.PUNCH
44.1kHz
DIGITAL
SETUP
SYNC OUT DRIVE
CLK SCSI
AUTO A.PUNCH
44.1kHz
SYNC OUT DRIVE
CLK SCSI
AUTO A.PUNCH
44.1kHz
SETUP
MB
Flashing
SURE ?
SYNC OUT DRIVE
CLK SCSI
AUTO A.PUNCH