Bryant 355AAV Installation Instructions Manual page 60

LOAD CALCULATION
________________
________________
________________
VENT PIPING
Termination Location
________________
________________
________________
________________
________________
Pipe Insulation
________________
________________
E2008 Bryant Heating & Cooling Systems D 7310 W. Morris St. D Indianapolis, IN 46231
Manufacturer reserves the right to discontinue, or change at any time, specifications or designs without notice and without incurring obligations.
CHECKLIST — DIRECT VENT (1 ---PIPE) INSTALLATION
Heating Load (Btuh)
Cooling Load (Btuh)
Furnace Model Selection
Roof or Sidewall
Vent Pipe Length
Vent Pipe Elbow Quantity
Pipe Diameter Determined from
Sizing Table
Pipe Sloped to Furnace
Over Ceilings
Low--- Ambient Exposed Pipes
________________
________________
________________
________________
CHECKLIST --- START ---UP
________________
________________
________________
________________
Safety Controls Check Operation
________________
________________
Printed in U.S.A. Edition Date: 12/08
60
Condensate Drain
Unit Level or Pitched Forward
Internal Tubing Connections
Free of Kinks and Traps
External Drain Connection Leak
Tight and Sloped
Condensate Trap Primed before
Start--- Up
Heat Tape Installed if Required
Gas Input Rate (Set Within 2
percent of Rating Plate)
Temperature Rise Adjusted
Thermostat Anticipator
Anticipator Setting Adjusted or
Cycle Rate (3 Cycles per Hr)
Selected
Primary Limit
Pressure Switches
Catalog No. II355A ---40---4
Replaces: II355A--- 40--- 3