Setting Bar Code Parameters - Brother P-Touch 2730 User Manual

EDITING A LABEL

Setting Bar Code Parameters

1
Press the Setup key to display the Setup menu, select "Bar Code Setup" using
the or
The Bar Code Setup screen is displayed.
2
Select an attribute using the
using the
Characters may not appear below the bar code even when "On" is selected for "Under #",
depending on the tape width being used, the number of lines entered, or the current
character style settings.
3
Press the OK or Enter key to apply the settings.
New settings are NOT applied if you do not press the OK or Enter key.
• The "C-Digit" (Check Digit) attribute is only available for the CODE39, I-2/5 and CODABAR
protocols
• Press the Escape key to return to the previous step.
• Press the Space key to set the selected attribute to the default value.
• Refer to the Bar Code Settings table for a list of all available settings.
Attribute
Protocol
Width
Under#
(characters printed
below bar code)
C.Digit
(check digit)
50
Creating a Bar Code Label
key, and then press the OK or Enter key.
or
or key.
Bar Code Settings
GS1-128 (UCC/EAN-128), UPC-A, UPC-E, I-2/5 (ITF),
key, and then set a value for that attribute
Value
CODE39, CODE128, EAN-8, EAN-13,
CODABAR
Small
Large
On
Off
Off
On
(only available for the CODE39, I-2/5
and CODABAR protocols)