Table of Contents
Advertisement
BJC-8500
3. APPLYING GREASE
When service parts are replaced, apply a coating of grease "MOLYKOTE HP-300,"
"HANARL FLX2," "EU-1" or "MOLYKOTE PG-662" at the specified locations. Apply a
sufficient amount of grease to form a thin and even coating to the specified locations.
Carriage
Carriage Shaft
Holder Unit
Gear Teeth Surface,
4 Locations,
Approx. 12mg each
MOLYKOTE HP-300
Do not apply grease to locations other than the specified locations. Also,
make sure that no grease is transferred from the specified locations onto
the surrounding parts.
When inserting the carriage shaft into
the carriage, remove the grease
applied to the carriage shaft holder
unit, and insert the carriage shaft
making sure that it is not rotated.
EU-1
Total Periphery
Approx. 80 to 180mg
Approx. 12mg each
Approx. 3mg each
per bushing seat
Figure 5-1 Grease Application Sections (1)
HANARL FLX2
100mm
5-3
Part 5: Maintenance
Apply grease so that
a light film is formed.
Advertisement
Table of Contents
