Table of Contents
Advertisement
BJC-5000
7.Machine
Temperature
Error
8.Waste Ink-Full
Warning/Error
<Corrective Action>
Visual check of the
waste ink absorber
Waste
ink absorbed is
75 % or more of
the limit ?
Yes
Replace the waste
END
ink absorber.
<Cause>
The thermistor is abnormal.
<Suspected Parts>
<Corrective Action>
<Cause>
The waste ink absorbers' estimated waste ink amount
has reached 95% (Warning) or 100% (Error).
<Suspected Parts>
Check to see how much ink the waste ink
absorber has absorbed.
(Check the rate of ink penetration for the entire
waste ink absorber as a guideline to determine
the waste ink counter setting value.)
No
1. Reset the waste
ink amount in the
EEPROM.
2. Replace the logic
board.
Clear the total of the waste ink amount
saved in the EEPROM.
5-21
Thermistor
Replace the logic board.
Waste ink absorbers, logic board
0% (clear), 25%, 50% or 75%
(See Part 3 "3.4 Service Mode. )
Part 5: Maintenance
Advertisement
Table of Contents
