Table of Contents
Advertisement
Available languages
Available languages
7. Separate the blower box and the lower part
of the support frame. Remove the 4 screws.
8. Connect the lower part of the support frame
to the part previously fixed to the ceiling with
8 screws (1/8x3/8") and 8 washers (
9. Adjust the overall height of the support frame.
Loosen and re-tighten the screws in the
height adjustment slots as necessary. Note
that the hood height is 13 - 3/8" and that the
bottom of the hood must be 24" min. and 30"
max. above the cooktop.
CONNECT DECORATIVE FLUE
1. Separate the 2 decorative flues; this
operation should be performed with great
care to avoid scratches. Place flues on
the floor and lift the inner flue without tiltins
on deformins the shape of the flues.
2. Secure the upper flue section to the brackets
of the support frame with the 2 screws (3/16
X 13/16").
3. Insert the lower flue section pushing it
upwards, and make it turn as far as the hole,
which has been made in the lower flue
section, is found available through its lower
opening. Partly screw one screw in the hole
and temporarily rest the lower flue section
on this (screw 1/8x3/8"). When making such
operation mind that the gasket is not
damaged.
LOWER
FLUE
SECTION
ø
3/16").
FRONT
LOWER PART OF
THE SUPPORT
BRACKET
OF THE
SUPPORT
FRAME
UPPER
FLUE
SECTION
SCREW
(1/8X3/8")
- 6 -
SCREWS
(1/8X3/8")
WASHERS
ø
FRAME
(
3/16")
SCREWS
(3/16X13/
16")
Advertisement
Table of Contents
