To replace the hard disk drive, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover. See "Removing the computer cover" on page 107.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 108.
4. Note the location of the four screws
assembly upward.
Figure 68. Pivoting the drive bay assembly
1
that secure the hard disk drive. Then, pivot the drive bay
.
Chapter 9
Installing or replacing hardware: 0104, 0154, 7539, and 7548
129