Accessing The System Board Components And Drives - Lenovo ThinkCentre A85 Hardware Maintenance Manual

4. To reinstall the front bezel, align the other three plastic tabs on the bottom of the front bezel with the
corresponding holes in the chassis, then pivot the front bezel inward until it snaps into position.
Figure 43. Reinstalling the front bezel
5. Go to "Completing the parts replacement" on page 138.

Accessing the system board components and drives

Attention:
Do not open your computer or attempt any repair before reading and understanding the "Important safety information"
in the ThinkCentre Safety and Warranty Guide that came with your computer. To obtain a copy of the ThinkCentre
Safety and Warranty Guide, go to:
http://www.lenovo.com/support
This section provides instructions on how to access the system board components and drives.
To access the system board components and drives, do the following:
1. Remove all media from the drives and turn off all attached devices and the computer. Then, disconnect
all power cords from electrical outlets and disconnect all cables that are connected to the computer.
2. Remove the computer cover to access the system board components. See "Removing the computer
cover" on page 107.
3. Remove the front bezel. See "Removing and reinstalling the front bezel" on page 108.
.
Chapter 9 Installing or replacing hardware: 0104, 0154, 7539, and 7548
109