Brother FAX100 Service Manual page 84

Selector
No.
1 Not used.
2
Min. detection time length of
PABX dial tone, required for
3
starting dialing
4
Not used.
5
6
Dial tone detection in PABX
7
"R" key function
8
NOTE: The WSW03 is not applicable in those countries where no PABX is supported, e.g.
U.S.A.
Selectors 2 through 4:
Upon detection of the PABX dial tone for the time length set by these selectors, the equip-
ment starts dialing.
These selectors are applicable only when both selectors 6 and 7 are set to "1" (Detection).
Selectors 6 and 7: Dial tone detection in PABX
These selectors activate or deactivate the dial tone detection function which detects a dial
tone when a line is connected to the PABX.
Setting both of these selectors to "1" activates the dial tone detection function so that the
equipment starts dialing upon detection of a dial tone when a line is connected.
Other setting combinations deactivate the dial tone detection function so that the equipment
starts dialing after the specified WAIT (3.5, 5.0, or 7.0 sec.) without detection of a dial tone
when a line is connected.
WSW03
(PABX* mode setting)
Function
Min. detection time length of PABX dial tone, required for starting
dialing
V – 32
Setting and Specifications
No. 2 3 4
0 0 0 :
0 0 1 :
0 1 0 :
0 1 1 :
1 0 0 :
1 0 1 :
1 1 0 :
1 1 1 :
No. 6 7
0 0 : No detection
(3.5 sec. WAIT)
0 1 : No detection
(5 sec. WAIT)
1 0 : No detection
(7 sec. WAIT)
1 1 : Detection
(Frequency only)
0: 1st dial tone
detection add
* PABX: Private automatic branch exchange
50 ms
210 ms
500 ms
800 ms
900 ms
1.5 sec.
2.0 sec.
2.5 sec.
1: No 1st dial
tone detection