Brother FAX100 Service Manual page 104

Selector
No.
1
Max. waiting time for voice signal
|
5
6
Two-way recording
7
Erasion of message stored in the
8
memory after the message
transfer
Selectors 1 through 5:
In the TAD mode, the equipment waits for voice signal for the time length specified by these
selectors before it automatically shifts to the facsimile message receive mode or disconnects
the line.
If the external TAD is connected to the equipment, the total length of the maximum waiting
time specified by these selectors and the delay time specified by WSW25 (selectors 1 and 2)
should not exceed 40 seconds.
Selectors 6 and 7: Two-way recording (For those models equipped with a built-in TAD)
These selectors select the specifications of the two-way recording feature.
Selector 8: Erasion of message (For those models equipped with a built-in TAD)
Setting this selector to "0" will erase the message recorded in the memory after the docu-
ment retrieval feature transfers the message.
Selector
No.
1
| Not used.
3
Copy resolution
4
5
Not used.
|
8
Selector 4: Copy resolution
This selector determines whether the resolution for multi-copy should be Fine or Superfine.
WSW21
(TAD setting 1)
Function
Max. waiting time for voice signal
WSW22
(Copy resolution setting)
Function
V – 52
Setting and Specifications
No. 1 2 3 4 5
0 0 0 0 0 : No detection
0 0 0 0 1 : 1 sec.
0 0 0 1 0 : 2 sec.
0 0 0 1 1 : 3 sec.
|
0 1 0 0 0 : 8 sec.
|
1 1 1 1 1 : 31 sec.
No. 6 7
0 0 : A (for U.S.A.)
0 1 : B (for Europe)
1 0 : C (without beep)
1 1 : D (OFF)
0: YES 1: NO
Setting and Specifications
0: Fine 1: Superfine
|
|