Chapter 6 Formatting Labels Using Menu Choices; Setting Vial Size - Brady LABXPERT User Manual

Chapter 6
Formatting Labels Using Menu Choices
This chapter provides information on the formatting options available through the LABXPERT
menu. See Menu Basics on page 9 for general menu use instructions.
Note: Most label formatting default settings are based on the cartridge installed in the
printer.
Note: In the instruction in this and other sections,
softkey choices will be named in brackets. For
example, if you are to press the Vial softkey, you will be
instructed to "Press [VIAL]". This means that you
should press the gray softkey just below VIAL.

Setting Vial Size

TM
The LABXPERT Laboratory Labeling System allows printing of vial labels, including multiple
put-up (vial/vial top) labels (see Chapter 8, Advanced Features for multi-zone label details). Vial
labels can be created using any continuous media; the length is automatically determined by the vial
size chosen.
To create a vial label:
1. Press
2. Press the [VIAL] softkey.
4. Pressing [NEXT] advances to the
next set of vial size options:
6. Make a vial size selection, then press
Note: You may also change a previously set vial size by selecting menu option [CONT], then
selecting [AUTO], then selecting a new vial size under the [VIAL] menu.
User's Manual
.
3. Press a vial size softkey, or [NEXT] for
more size options.
5. Pressing [NEXT] again advances to the
[AUTO] option. Selecting [AUTO] will
clear a previously set vial size.
.
TM
17