Rear-Wheel Stand - BMW K 1300 S Rider's Manual

The sensor ring of the
BMW Motorrad Integral
ABS can be damaged. motorcycle is raised too far at the
Only push the left mounting pin front, the center stand lifts off the
ground and the motorcycle can
so far inward that it does not
tip over to the side.
touch the sensor ring.
When raising the motorcycle,
Push two mounting pins 2
make sure that the center stand
through triangles of brake
remains on the ground.
caliper support toward inside
so that front wheel can still be
rolled through.
Tighten adjusting screws 1.

Rear-wheel stand

Installing rear-wheel
stand
Use basic stand with tool num-
ber (0 402 245) with rear axle
adapter (0 402 250).
If the motorcycle is resting
on the center stand: The
Set desired height of rear
wheel stand using bolts 1.
Apply uniform pressure to push
Remove the lock washer 2; to
front wheel stand down and
do so, press the unlock but-
raise motorcycle.
ton 3.
Make sure ground is level and
firm and place the motorcycle
on its side stand.
8
117
z