Performance Logging; Configuration Tab - Cisco WS-C3550-12G User Manual

Chapter 8 Interface and Subinterface Management
•
•

Performance Logging

The Performance Logging area contains the buttons to enable data logging of all the interface attributes
of the interface.
•
•
Note The logged data is available to you through the Cisco EMF Performance Manager. Refer to the
Cisco Element Management Framework User Guide for more information about the Performance
Manager.

Configuration Tab

The following areas are available on the Configuration tab of the ATM/E3 Interface Management
window:
•
•
•
•
•
OL-4930-01
Connector Present—Indication if a cable is connected to the interface. If the ifAdminStatus is down,
then this value cannot be determined and an "unknown" message is given. This attribute is read-only.
This attribute can have the following values:
yes—Cable is connected to the interface.
–
no—Cable is not connected to the interface.
–
unknown—Cannot determine if a cable is connected to the interface.
–
Number of Resets—Number of times the interface internally reset. This attribute is read-only.
Start—Turns on performance data logging.
Stop—Turns off performance data logging.
General
Layer 2
Layer 3
Private VLAN Edge
Actions
ATM/E3 Interface Management Window
Cisco Catalyst Switch Manager User Guide
8-85