Enabling Communication Between Network Elements And Devices - Cisco WS-C3550-12G User Manual

Enabling Communication Between Network Elements and Devices

Enabling Communication Between Network Elements and
Devices
Before commissioning, a communication must be established with the deployed Network Element if it
was deployed under one of the following circumstances:
•
•
•
Note If the SNMP read/write community strings and device passwords were identified during the manual
deployment process but the Network Element is in the decommissioned state, the basis for
communication with the device is established through the Deployment Wizard but the Network Element
object must be commissioned. For instructions on commissioning a Network Element, see the
Commissioning Network Elements" section on page
To enable communication between the Network Element and the device, perform the following:
Step 1 Launch the Network Element Management window by performing one of the following:
•
•
The Network Element Management window appears.
Cisco Catalyst Switch Manager User Guide
4-22
IP Auto Discovery
Predeployment
Manual Deployment to the decommissioned state where the SNMP read/write community strings
and device passwords were not identified
Right–click a Site object within the Network or Physical containment views, then choose
CSM/7600 Manager > NE Config/Mgmt.
Right–click a Network Element object within the Network or Physical containment views, then
choose NE Config/Mgmt.
Chapter 4 Deploying the Cisco Catalyst Switch Manager
4-25.
"Manually
OL-4930-01