Installing the VG248
Warning
Attaching the Brackets
Caution
Cisco VG248 Analog Phone Gateway Hardware Installation Guide
3-2
To prevent bodily injury when mounting or servicing this unit in a
rack, you must take special precautions to ensure that the system
remains stable. The following guidelines are provided to ensure
your safety:
This unit should be mounted at the bottom of the rack if it is the only unit in
•
the rack.
When mounting this unit in a partially filled rack, load the rack from the
•
bottom to the top with the heaviest component at the bottom of the rack.
•
If the rack is provided with stabilizing devices, install the stabilizers before
mounting or servicing the unit in the rack.
The chassis comes with brackets for use with a 19-inch rack. To install the chassis
in a rack, attach the brackets in one of the following ways:
With the front panel forward (see
•
•
With the rear panel forward (see
These figures
(Figure 3-1
side of the chassis. The second bracket connects to the opposite side of the
chassis.
Only use the screws provided when attaching the brackets.
Figure
3-1)
Figure
3-2)
and
Figure
3-2) show how to connect the bracket to one
Chapter 3
Installing the VG248
78-13154-01