Installing The Sce 2000 Platform - Cisco SFE2000P Installation And Configuration Manual

Installing the SCE 2000 Platform

Table 4-2
Specification
Relative humidity
Heat dissipation
*Short term is defined as not more than 96 consecutive hours, not more than 15 days in one year. 360
hours total in any given year, but no more than 15 occurrences in a one-year period.
Table 4-3
Approval
EMC
Safety
For more complete information regarding safety and regulatory compliance, refer to the Regulatory
Compliance and Safety Information for the Cisco Service Control Engine document.
The DC-powered SCE 2000 should be installed in a Restricted Access Location only.
Installing the SCE 2000 Platform
The SCE 2000 operates as either a tabletop or a rack-mounted unit. A rack-mounting kit is included with
the SCE 2000 when it is shipped from the factory. The kit provides the hardware needed (see
Component List
•
•
If you are not rack-mounting your SCE 2000 , place it on a sturdy tabletop or workbench. A rubber feet
kit is included for tabletop installations.
This section provides instructions for the physical installation of the SCE 2000 platform, including how
to install the SCE 2000 in a rack, how to install the SCE 2000 on a tabletop or workbench, and how to
properly ground the SCE 2000 platform. The section contains the following topics:
•
•
•
•
Cisco SCE 2000 4xGBE Installation and Configuration Guide
4-4
SCE 2000 Environmental Requirements
SCE 2000 Approvals Specifications
) to mount the SCE 2000 in either of two types of standard 19-inch equipment rack:
19-inch rack with only two posts in the front — Use the supporting brackets included in the kit
19-inch rack with four posts, two in the front and two in the back — Use the crossrail supports
included in the kit
Installation Precautions
How to Install the SCE 2000 on a Workbench or Tabletop
Rack-Mounting a SCE 2000 Platform
How to Attach a Chassis Ground Connection
Chapter 4
Acceptable Range
5% to 95% (non-condensing)
683 BTU/hour
Specification
CE Mark
•
EMISSIONS: FCC Part 15 CFR 47 Class A,
•
EN 55022 Class A, CISPR22 Class A, VCCI
Class A, AS/NZS CISPR22 Class A
Immunity - EN 50082-1 EN 55024, CISPR24
•
(ESD, RFI, EFT, etc.) (Commercial)
UL/CSA 60950, IEC60950, EN60950, AS/NZS,
60950, NOM-019,IEC/EN60825-1, -2,
21CFR1040, 73/23/ECC
Installation and Maintenance
SCE 2000
OL-7824-06