Cisco SFE2000P Installation And Configuration Manual page 85

Chapter 5 Connecting the Management Interfaces and Performing Initial System Configuration
The procedure described below is a presentation of all the questions in the topology configuration. In
actual practice, all questions may not be presented for a particular configuration, depending on the
topology deployed.
Study the examples that follow to understand the procedure for various topologies.
SUMMARY STEPS
1.
2.
3.
4.
5.
6.
7.
DETAILED STEPS
Step 1 Enter the topology configuration menu.
Would you like to enter the Topology configuration menu? [no]: y
Type yand press Enter.
The topology configuration dialog begins.
Specify the connection mode.
Step 2
•
•
Enter Connection mode:
1- inline
2- receive-only
Enter your choice [1]:
Specify the deployment type.
Step 3
•
•
Is this a cascade deployment? [no]:
Specify the physically-connected-link index.
Step 4
•
•
Enter Physically connected link:
0- link-0
1- link-1
Enter your choice [0]:
Specify the SCE 2000 priority.
Step 5
•
•
OL-7824-06
Enter the topology configuration menu.
Specify the connection mode.
Specify the deployment type.
Specify the physically-connected-link index.
Specify the SCE 2000 priority.
Specify the On-failure link behavior.
Specify the status of the SCE 2000 after abnormal boot.
To define inline connection mode, press Enter.
To define receive-only connection mode, type 2and press Enter.
To specify a Single-SCE Platform deployment, press Enter.
To specify a Cascade deployment, type yand press Enter.
To specify link-0 , press Enter.
To specify link-1 , type 1and press Enter.
To specify Primary , press Enter.
To specify Secondary , type 2and press Enter.
Cisco SCE 2000 4xGBE Installation and Configuration Guide
Initial System Configuration
5-21