Transceivers Supported By The Cisco Nexus 2232Pp Fex; Sfp Transceivers - Cisco SD2008T-NA Installation Manual

Cisco Nexus 2232PP FEX
S e n d d o c u m e n t a t i o n c o m m e n t s t o n e x u s 5 k d o c s @ c i s c o . c o m

Transceivers Supported by the Cisco Nexus 2232PP FEX

The Cisco Nexus 2232PP FEX supports SFP+ Ethernet optical and copper transceivers and optical FEX
Transceivers (FETs) for up to eight fabric uplink connections to the following Cisco Nexus 7000 Series
switch I/O modules:
•
•
•
•
You must use the same transceivers on both ends of the same uplink cable.
To get the fully dedicated 10-Gbps bandwidth through a M1 Series 32-port 10-Gigabit Ethernet I/O
Note
module, connect each FEX to one port in a set of four shared ports on the module (you connect each set
of shared ports to one FEX) and use the shared mode on the I/O module. If you are using the F2 Series
48-port 10-Gigabit Ethernet I/O module (N7K-F248XP-25) or the M2 Series 24-port 10-Gigabit
Ethernet I/O module (N7K-M224XP-23L), you can connect the FEX to any of its ports.
The Cisco Nexus 2232TM FEX also supports RJ-45 connectors for up to 32 downlink connections to
hosts.
Table 2-8 Supported Transceivers and Connector for the Cisco Nexus 2232TM FEX Uplink Interfaces
Transceiver or
Connector
FET-10G
GLC-LH-SM
GLC-SX-MM
GLC-T
SFP-10G-LR
SFP-10G-SR
SFP-GE-L
SFP-GE-S
SFP-GE-T
1
SFP -H10GB-CU1M
1
SFP -H10GB-CU3M
1
SFP -H10GB-CU5M
SFP -H10GB-ACU7M
SFP -H10GB-ACU10M
1. The SFP-H10GB-CUxM transceivers are not supported by the M1 Series 32-port 10-Gigabit Ethernet I/O module (N7K-M132XP-12). These transceivers
are supported by the other Cisco Nexus 7000 Series I/O modules.
Cisco Nexus 2000 Series Hardware Installation Guide
2-24
F2 Series 48-port 10-Gigabit I/O module (N7K-F248XP-25)
M1 Series 32-port 10-Gigabit Ethernet I/O module (N7K-M132XP-12)
M1 Series 32-port 10-Gigabit Ethernet I/O module with XL option (N7K-M132XP-12L)
M2 Series 24-port 10-Gigabit I/O module (N7K-M224XP-23L)
Table 2-2 lists the transceivers supported by this FEX for its uplink and downlink connections.
Fabric Host
Cable Interface Interface
Type (Uplink) (Downlink) Comments
Optical X –
Optical – X
Optical – X
Copper – X
Optical X X
Optical X X
Optical – X
Optical – X
Copper – X
Copper X X
Copper X X
Copper X X
Copper X X
Copper X X
Chapter 2 Using a Fabric Extender with a Cisco Nexus 7000 Series Switch
10 Gigabit FEX transceiver
Gigabit SFP transceiver
Gigabit SFP transceiver
Gigabit SFP transceiver
10 Gigabit long range transceiver (up to 6.2 miles [10 km])
10 Gigabit Short range transceiver (up to 984 feet [300 m])
Gigabit SFP transceiver
Gigabit SFP transceiver
Gigabit SFP transceiver
10 Gigabit Twinax, passive transceiver (3.3 feet [1 meter])
10 Gigabit Twinax, passive transceiver (9.8 feet [3 meters)
10 Gigabit Twinax, passive transceiver (16.4 feet [5 meters])
10 Gigabit Twinax, active transceiver (23.0 feet [7 meters])
10 Gigabit Twinax, active transceiver (32.8 feet [10 meters])
OL-19013-05