Igmp_Querier Messages - Cisco IE-3000-8TC Message Manual

Chapter 2 Message and Recovery Procedures

IGMP_QUERIER Messages

This section contains the IGMP querier messages.
Error Message IGMP_QUERIER-4-NO_IP_ADDR_CFG: The IGMP querier cannot send out
General Query messages in VLAN [dec] because there is no IP address configured on
the system.
Error Message IGMP_QUERIER-4-SNOOPING_DISABLED: The IGMP querier is operationally
disabled in VLAN [dec] because IGMP snooping has been disabled in this VLAN.
Error Message IGMP_QUERIER-6-PIM_DISABLED: The IGMP querier is now operationally
enabled in VLAN [dec] because PIM is no longer enabled on the SVI.
Error Message IGMP_QUERIER-6-SNOOPING_ENABLED: The IGMP querier is now operationally
enabled in VLAN [dec] because IGMP snooping is no longer disabled.
OL-13020-01
You must specify an IP address for the IGMP querier at either the global or per-VLAN
Explanation
level. [dec] is the VLAN ID.
Configure a source IP address for the IGMP querier.
Recommended Action
IGMP snooping is disabled on this VLAN. Do not enable the IGMP querier when IGMP
Explanation
snooping is disabled. [dec] is the VLAN IDs.
Confirm that IGMP snooping is enabled both globally and on the VLAN.
Recommended Action
Protocol-Independent Multicast (PIM) is disabled on the switch virtual interface (SVI),
Explanation
and the IGMP querier function is now enabled. [dec] is the VLAN ID.
No action is required.
Recommended Action
IGMP snooping was enabled. As a result, the IGMP querier function is now enabled.
Explanation
[dec] is the VLAN ID.
Recommended Action No action is required.
IGMP_QUERIER Messages
Cisco IE 3000 Switch System Message Guide
2-31