Dot1X_Switch Messages - Cisco IE-3000-8TC Message Manual

DOT1X_SWITCH Messages

Error Message DOT1X-5-SECURITY_VIOLATION: Security violation on interface [chars],
New MAC address [enet] is seen.
DOT1X_SWITCH Messages
This section contains the IEEE 802.1x messages for switches.
Error Message DOT1X_SWITCH-5-ERR_ADDING_ADDRESS: Unable to add address [enet] on
[chars]
Error Message DOT1X_SWITCH-5-ERR_INVALID_PRIMARY_VLAN: Attempt to assign primary
VLAN [dec] to 802.1x port [chars]
Error Message DOT1X_SWITCH-5-ERR_INVALID_SEC_VLAN: Attempt to assign invalid
secondary VLAN [dec] to PVLAN host 802.1x port [chars]
Cisco IE 3000 Switch System Message Guide
2-12
Explanation A host on the specified interface is trying to access the network or to authenticate in a
host mode that does not support the number of hosts attached to the interface. This is a security
violation, and the port is put in the error-disabled state.
Recommended Action Ensure that the interface is configured to support the number of attached hosts.
Enter the shutdown interface configuration command and then the no shutdown interface
configuration command to restart the port.
The client MAC address could not be added to the MAC address table because the
Explanation
hardware memory is full or the address is a secure address on another port. [enet] is the supplicant
MAC address, and [chars] is the interface. This message might appear if the IEEE 802.1x feature is
enabled.
If the hardware memory is full, remove some of the dynamic MAC addresses.
Recommended Action
If the client address is on another port, manually remove it from that port.
An attempt was made to assign a primary VLAN to an IEEE 802.1x port, which is not
Explanation
allowed. [dec] is the VLAN, and [chars] is the port.
Update the configuration to use a different VLAN.
Recommended Action
An attempt was made to assign a nonsecondary VLAN to a private VLAN host IEEE
Explanation
802.1x port. [dec] is the VLAN, and [chars] is the port.
Change the mode of the port so that it is no longer a private VLAN host port,
Recommended Action
or use a valid secondary VLAN.
Chapter 2 Message and Recovery Procedures
OL-13020-01