Correction Tape - Nakajima AE-710 Operation Manual

Correction Tape
Removing correction tape
l) Open the top cover and remove the ribbon cassette as explained
under "Removing ribbon cassette".
2) Remove the left hnd right spools from the spindles.
Note:
Be sure not to pull the spindle hub when removing the left spool.
3) Grasp both spools and bring them back to straighten the tape.
Pull the correction tape to take up any slack and lift it out.
Installing correction tape
1) Unwind the correction tape. Hold rhe rwo spools with your
fingers.
2) Carefully lower the correction tape in berween the ribbon guides
and the card holder.
Note:
Make sure the coated side of the correction tape faces the card
holder.
3) Fit the full spool of the correction tape onro rhe left supply
spindle and press the spool until it snaps into place.
4) Fit the right spool (the one with the knob) on the right takeup
spindle.
5)Tum the right spool toward you until the colored portion of rhe
tape disappears.
Note:
Check to make sure the correction tape goes behind the left and
right guide rollers.
6) Reposition the nbbon cassetre and close the top cover.
2'l