Repeat Play; Displaying The Text; Information; In Case Of Difficulty - Alpine 68-16909Z79-A Owner's Manual

Repeat Play

Only Repeat One is available for the iPod/iPhone.
Repeat One:
A single song is repeatedly played back.
1
Press 4.
The song is played back repeatedly.
(off)
(Repeat
One)
2
To cancel repeat play, select (off) with the
above procedure.
• During repeat playback, no other songs are selectable by
pressing or .

Displaying the Text

You can display the tag information of a song in the iPod/
iPhone.
Press VIEW.
Each press changes the display.
• When the TEXT SCR is set to SCR MANU, press and
hold VIEW for at least 2 seconds, the current text will be
scrolled one time.
TRACK NO./ELAPSED TIME
TRACK NO./CLOCK
ALBUM NAME*
TRACK NO./ELAPSED TIME
* TAG information
"ARTIST"/"ALBUM"/"SONG" is displayed if there is
no tag information.
• Only alphanumeric characters (ASCII) can be displayed.
• If the artist, album or song name, created in iTunes, has
too many characters, songs may not be played back
when connected to the adapter. Therefore, a maximum of
250 characters is recommended. The maximum number
of characters for the head unit is 70 (70 byte).
• Some characters may not be correctly displayed.
• "NO SUPPORT" is displayed if text information is not
supported by the unit.
22
-EN
ARTIST NAME*
SONG TITLE*

Information

In Case of Difficulty

If you encounter a problem, please turn the power off, then
on again. If the unit is still not functioning normally, please
review the items in the following checklist. This guide will
help you isolate the problem if the unit is at fault.
Otherwise, make sure the rest of your system is properly
connected or consult your authorized Alpine dealer.
Basic
No function or display.
• Vehicle's ignition is off.
- If connected following instructions, the unit will not
operate with the vehicle's ignition off.
• Improper power lead (Red) and battery lead (Yellow)
connections.
- Check power lead and battery lead connections.
• Blown fuse.
- Check the fuse of the unit; replace with the proper
value if necessary.
Radio
Unable to receive stations.
• No antenna or open connection in cable.
- Make sure the antenna is properly connected; replace
the antenna or cable if necessary.
Unable to tune stations in the seek mode.
• You are in a weak signal area.
- Make sure the tuner is in the DX mode.
• If the area you are in is a primary signal area, the antenna
may not be grounded and connected properly.
- Check your antenna connections; make sure the
antenna is properly grounded at its mounting location.
• The antenna may not be the proper length.
- Make sure the antenna is fully extended; if broken,
replace the antenna with a new one.
Broadcast is noisy.
• The antenna is not the proper length.
- Extend the antenna fully; replace it if it is broken.
• The antenna is poorly grounded.
- Make sure the antenna is grounded properly at its
mounting location.