Priming The Water Supply System - Electrolux 241737900 Use And Care Manual

Electrolux side-by-side refrigerator use & care guide
Table of Contents

Advertisement

20
Automatic Ice & Water Dispenser

PRIMING THE WATER SUPPLY SYSTEM

Your refrigerator's water supply system includes several tubing lines, an advanced
water filter, a distribution valve bank, and a reserve tank to ensure ample supply to
the ice and water dispenser at all times. This system needs to be completely filled
with water when first connected to an external supply line.
CA
CAUTION
CA
UTION
UTION
UTION
CA
CA
UTION
!
For proper dispenser operation, recommended water supply pressure should fall between
between 1.4 and 6.9 bars. Excessive pressure may cause water filter to malfunction.
To prime the water supply system:
1 Begin filling the tank by pressing and holding a drinking glass against the
water dispenser paddle.
2 Keep the glass in this position until water comes out of the dispenser. It may
take about 1½ minutes.
3 Continue dispensing water for about 3 minutes to flush the system and
plumbing connections of any impurities (stopping to empty the glass as
necessary).
NO
NO
TE
TE
NO
NOTE
NO
TE
TE
The water dispenser has a built-in device that shuts off the water flow after 3 minutes of
continuous use. To reset this shutoff device, simply release the dispenser paddle.
CA
CA
CAUTION
UTION
UTION
UTION
CA
CA
UTION
!
Pushing the dispensing paddle in for more than 4 minutes may cause the dispenser motor
to overload and stop. The overload protector resets automatically after 3-4 minutes.
ICE DISPENSER OPERATION & CARE
The ice maker, ice bin, and dispenser feeding mechanism are located in the top of
the freezer compartment. After the refrigerator is installed properly and has cooled
for several hours, the ice maker can produce ice within 24 hours. It can completely
fill an ice bin in about two days.
The ice maker produces 4-6 pounds of ice every 24 hours depending on usage
conditions. Ice is produced at a rate of 8 cubes every 75 to 90 minutes.
IMPOR
IMPOR
IMPOR
IMPOR
IMPORT T T T T ANT
The ice maker is turned on at the factory so it can work as soon as you install your
refrigerator. If you cannot connect a water supply, turn the ice maker's On/Off switch to Off.
Otherwise, the ice maker's fill valve may be noisy when it attempts to operate without water.
ANT
ANT
ANT
ANT

Advertisement

Table of Contents
loading

This manual is also suitable for:

Side-by-side

Table of Contents