√ Resolve many service issues over the phone at your convenience! √ If we can’t resolve your service issue, we’ll schedule a reputable local service technician for you! √ Order Genuine Electrolux Parts & Accessories √ Purchase Extended Warranty Protection READ AND SAVE THESE INSTRUCTIONS Important Safety Instructions ...
• Do not plug the unit into an electrical outlet controlled by a wall switch or pull cord to prevent the refrigerator from being turned off accidentally. Pressing and holding the On/Off button for 3 seconds, located on the left side of the temperature control panel (Electronic controls), or turning the Freezer and Fresh Food controls to “0”...
55° F. Upgrading your refrigerator with a Garage Kit will lower the minimum operating temperature of your unit to 34° F. This kit can be ordered through the Electrolux Solutions Hotline (see back cover). INSTALLATION Installation Clearances •...
Depending on your local/state building codes, Electrolux recommends for homes with existing valves its Smart Choice water line kit 5305513409 (with a 6 ft. stainless steel water line) and for homes without an existing valve, Frigidaire recommends its Smart Choice water line kit 5304410264 (with a 20 ft.
Door Stop 12. Position refrigerator door onto bottom hinge pin and screw center hinge pin Stop Screw through center hinge into top of door. Close refrigerator door to help align hinge Washer hole. Hinge 13. Tighten center hinge pin with adjustable wrench.
Page 6
TRIM REMOVAL (fULL-LENGTH TRIM MODELS ONLY) Screw In some models, the refrigerator door has a full length trim piece which continues from the bottom of the handle to the bottom Handle of the door. The top of the trim attaches to the handle bracket (Figure 1) or fits around the base of the handle (Figure 2).
Page 7
7. Reverse steps 1 - 6 to reinstall doors To Remove Handles 1. Firmly hold freezer handle while loosening set screws with 3/32” allen wrench. Remove freezer handle. 2. Repeat step 1 for refrigerator door. Figure 2...
COOL DOWN PERIOD To ensure safe food storage, allow the refrigerator to operate with the doors closed for at least 8 to 12 hours before loading it with food. REfRIGERATOR & fREEzER CONTROLS NOTE When making changes to the temperature controls, wait 24 hours for the temperature to stabilize before making additional changes.
If your refrigerator has an automatic ice maker, it will provide a sufficient supply of ice for normal use. During the initial startup of your refrigerator, no ice will be produced during the first 24 hours of operation. Air in new plumbing lines may cause the ice maker to cycle two or three times before making a full tray of ice.
Condenser fan If condenser coils are located underneath your refrigerator as shown in the drawing at the left, you have a condenser fan. You may hear air being forced through the condenser by the condenser fan.
Page 11
Always unplug the power cord from the electrical outlet before cleaning. CAUTION • When moving the refrigerator, pull straight out. Do not shift the refrigerator from side to side as this may damage the floor. Be careful not to move the refrigerator beyond the plumbing connections.
This warranty only applies in the USA and Canada. In the USA, your appliance is warranted by Electrolux Major Appliances North America, a division of Electrolux Home Products, Inc. In Canada, your appliance is warranted by Electrolux Canada Corp.
Cabinet light not working. Replace light bulb. Ensure plug is tightly pushed into electrical outlet. Light switch may be stuck. Push in light switch, located on the refrigerator control box, to release. Automatic ice maker not working Ensure the Wire Signal Arm is not in UP position.