Table of Contents
Advertisement
SYMPTOM
Alarm doesn't Arm/Disarm.
Alarm will not Passively Arm.
Alarm will not enter Code
Learning Mode.
Alarm chirps 4 times 30
seconds
after
system
Armed.
Parking lights do not flash.
System Arms and Disarms but
doesn't chirp siren
PROBABLE CAUSE
Alarm in Valet Mode; Ignition
input has voltage on it; Missing
+12V or ground.
Dip Switch #4 is OFF, wrong
polarity door input wire,
Yellow ignition input has 12V+
on it.
Ignition was not left in the on
position after turning it on &
off three times; Sequence not
performed rapidly enough (5
sec.); Valet/Override Switch is
defective or not plugged in.
Factory Dome light Delay is
is
longer than 30 seconds; Door
open or defective pin switch;
Shock sensor is not properly
adjusted or defective.
Wrong wire connected to the
White wire, or requires a
negative output.
Chirp Delete mode is engaged.
10
SUGGESTED CORRECTION
Take alarm out of Valet mode;
Turn key off and verify yellow
wire is connected to correct
ignition wire; Check +12V and
ground connections.
Change Dip Switch #4 to on
position; Correct door switch
polarity; Change ignition input
wire; Make sure alarm is not in
Valet.
Leave ignition in on position;
Repeat procedure quicker;
Replace valet switch.
If dome light delay is longer
than 30 seconds no correction
necessary; Replace defective pin
switch; Adjust or replace shock
sensor.
Correct the wire connected to
the White wire, Using a SPDT
relay reverse polarity on white
wire (see diagrams).
Enter programming step 5 and
press transmitter button 2.
Advertisement
Table of Contents
