Table of Contents
Advertisement
CHAPTER 2 – WORKING WITH DAVINCI
BATTERY INSTALLATION
Before you start using the daVinci, you must install the two included
AAA alkaline batteries.
The battery door, located on the back of the unit, is locked into place.
1.
Remove the battery cover by pressing the hinge down and pulling
the battery cover open.
2.
Insert the two new batteries, following the signs inside the battery
compartment.
3.
Carefully place the battery cover in its place and press the cover
gently into its location until cover is locked in position.
DO NOT APPLY UNNECCESARY FORCE WHEN REMOVING OR
REPLACING THE BATTERY COVER. THE COVER SHOULD
EASILY FIT INTO ITS PLACE IN THE BACK OF THE UNIT.
NOTE: Battery voltages are constantly monitored; a low battery
warning message will show when power level gets too low. Replace the
batteries when this message is displayed. You can change the battery
without losing any information. Do not try to operate or synchronize the
daVinci with a low battery; data can be corrupted or lost.
The data that has been synchronized to the computer can be restored
to the daVinci by synchronizing again. For detailed software use
instructions, see the "help and instruction files" provided with the
synchronization software.
YOU MUST RESET THE DAVINCI BEFORE USING IT FOR THE
FIRST TIME. FOLLOW THESE RESET INSTRUCTIONS:
5
Hide quick links:
Advertisement
Table of Contents
