Setting Up Wpa-Psk [Tkip] Or Wpa2-Psk [Aes] Security - NETGEAR WNA1000 - Wireless-N 150 USB Adapter User Manual

Setting Up WPA-PSK [TKIP] or WPA2-PSK [AES] Security

To configure WPA-PSK security:
1. Run the WNA1000 Smart Wizard.
a. Make sure that the WNA1000 software is installed and the wireless-N USB adapter is
fully inserted in a USB port in your computer.
b. Use the icon to open the Smart Wizard. The Settings tab displays.
2. Configure the Security settings.
a. In the Profile field, select the profile, or type in a profile name.
b. In the Network Name (SSID) field, and then select the network, or enter the SSID.
Note: You will not get a wireless network connection unless the network SSID
c. In the Security section, select WPA-PSK [TKIP] or WPA2-PSK [AES], and enter the
passphrase.
Figure 2-12
For more about WPA2-PSK, see the link to
3. Save your settings in a profile.
a. Click the Save Profile button. All the configuration settings are saved in this profile.
b. Click Apply, and then click Close to exit the Smart Wizard.
NETGEAR Wireless-N 150 USB Adapter WNA1000 User Manual
matches exactly what is configured in the access point.
v1.0, August 2009
"Wireless Communications:" in Appendix B.
2-15