Generating A Pin To Connect To A Wireless Access Point Or Router; V1.0, August - NETGEAR WNA1000 - Wireless-N 150 USB Adapter User Manual

NETGEAR Wireless-N 150 USB Adapter WNA1000 User Manual
7. Within 2 minutes, return to the WNA1000 Smart Wizard screen, and click
Wizard initiates your wireless connection.
Note: The adapter security is set to WPA-PSK [TKIP] by default. Some WPS routers
support WPA2-PSK [AES], with the same SSID and passphrase. You can
change the adapter to WPA2-PSK [AES] using the Security setting in the
Settings screen.
8. You can use the Status Bar to verify your network connection. For more information, see
"Smart Wizard Status Bar" on page
Generating a PIN to Connect to a Wireless Access Point or
Router
There are two ways to enable the wireless-N USB adapter to join a wireless network: using the
router or access point's security PIN; or using the wireless-N USB adapter's security PIN (the
wireless-N USB adapter can generate a PIN to connect to the router).
To use either the router's security PIN or the adapter's security PIN:
1. Click the icon to open the Smart Wizard of the wireless-N USB adapter. On the status bar,
click Join a Network (or click the Networks tab and select the network). The wireless-N
USB adapter detects a network with WPS.
Figure 2-4
2. To use a PIN, select No, and then click Next, then do either of the following:
2-6
1-9. Click Close to exit the Smart Wizard.

v1.0, August 2009

. The Smart