iRobot Verro 100 Owner's Manual page 4

Tips
Tip
Clean the filter bag regularly. Verro uses the force of the water pumped through its filter bag
to move properly. If the filter bag is not kept clean, Verro will not move or clean properly.
Tip
iRobot Verro 100 includes one fine filter bag, ideal for filtering small debris (algae, sand,
etc.) and regular maintenance. Additional fine filter bags (as well as mesh filter bags, ideal
for when the pool contains a significant quantity of large debris) are available for purchase
at store.irobot.com
Tip
To keep the power cord from becoming kinked and tangled, always reverse the position of the
locking pin to the opposing side of the axle after each use.
Tip
Periodically straighten the floating power cord with the Detangler.
Tip
Store your robot in a dry place out of direct sunlight at a temperature between 50 and 104
degrees Fahrenheit. The Power Supply is water resistant, but not waterproof and may be
damaged by rain. Important: Failure to properly store Verro will result in loss of warranty.
Tip
The Verro 100 Power Supply has an automatic timer that shuts Verro OFF after approximately
two hours of operation. When this happens, the power switch will remain ON. To start
another cleaning cycle, switch the Power Supply OFF and then back ON and then press
the reset button.
Tip
Periodically, clean filter bag using cold water only on gentle cycle. Never use detergents,
fabric softeners, bleach or other additives and do not machine dry. This will cause permanent
damage to your filter bag.

iRobot Verro Owner's Manual