iRobot Verro 100 Owner's Manual page 11

Using Verro
8
Wait 20 minutes before removing Verro from the pool to allow the pump motor to cool.
Shut off and unplug the Power Supply every time you remove the cleaner from the water.
Always remember to turn the Power Supply OFF and unplug it from the power outlet before
removing the cleaner from the pool.
9
Unplug the Power Supply from the GFCI outlet. Never leave the Power Supply plugged in
when Verro is not in use.
10
Unplug the floating power cord from the Power Supply.
Use the floating power cord to pull Verro to the edge of the pool, then use the handle to
11
lift it out of the water. Water will drain from Verro as it is lifted. CAUTION: Removing Verro
by its floating power cord may cause severe damage to the cord requiring costly repairs.
1 Store Verro and its Power Supply in a dry area out of direct sunlight. The Power Supply
is water resistant, but not waterproof, and may be damaged by rain.
(cont...)
www.irobot.com
11