Troubleshooting
Problem
Verro is not removing
attached dirt
and debris
The floating power
cord is tangled
or kinked
Verro gets stuck on
its floating power cord
Verro will not start a
cleaning cycle
(cont...)
likely Cause
The filter bag needs to
be cleaned
Flaps in the vacuum
intakes at bottom of
robot are blocked
The pump propeller is
fouled by dirt or debris
The floating power cord
is twisted
The floating power cord
is twisted
Reset required
Verro is not plugged
into the Power Supply
The Power Supply is not
plugged in
what to Do
Clean the filter bag. (p. 15)
Check the flaps in the vacuum intakes.
(p. 22)
Clean the pump propeller. (p. 20)
Use Detangler to untwist the cord. (p. 19)
Use Detangler to untwist the cord. (p. 19)
Turn Power Supply OFF and then back ON.
Press reset button.
Plug Verro into the Power Supply.
Plug the Power Supply into GFCI outlet only.
www.irobot.com
5