Right Needle - Baby Lock imagine BLE1AT-2 Instruction Manual

S

Right Needle

E
R
1. Turn the handwheel and line up the green marks on the machine and the handwheel.
Set the needle threader selector on "R" for right needle (see page 13, fig. B .)
G Note: Be sure to push the needle threader selector all the way to "R".
2. Place the thread on the second from left spool pin on the thread stand (fig.A). Thread needle
thread guides 1 and 2, through the groove on the face plate and through guides 3, 4, 5, 6 and 7.
E
Pull a 6-inch (15 cm) length of thread through guide 7.
3. Lower the presser foot to engage the tensions.
R
4. Hold the thread between your left thumb and middle finger (see page 13 fig.B ). With your right
index finger, hold the thread horizontally in front and just below the needle eye. With the left index
finger, push the needle threader lever down to insert the hook into the needle eye. Slip the thread
into the threader hook guides in front of the needle. Carefully release the needle threader lever and
S
remove your right index finger, allowing the thread to be pulled through the needle eye.
5. Continue pulling the thread loop manually through the needle eye.until a single strand is threaded.
E
Place the thread under the presser foot and to the left.
T
U
P
12
A
Handwheel