Pedal Effect Block - Korg Toneworks AX1500G Owner's Manual

4. Appendices

PEDAL effect block

These effect models let you use the expression pedal to control
the effect in realtime. They include a volume pedal, modulation-
type effects such as VOX WAH—RING MOD, and ambience-
type effects such as HOLD DELAY—SAMPLE&PLAY.
VOX WAH—RING MOD cannot be used simultaneously
with the MODULATION effect block. Nor is it possible to
use HOLD DELAY—SAMPLE&PLAY simultaneously with
the AMBIENCE effect block.
PEDAL
VOLUME
VOX WAH
TRAVELER
TALK
CHORUS/FLANGER
U-VIBE
PITCH BEND
RING MOD
HOLD DELAY
TAP DELAY
SAMPLE&PLAY
Volume
This is a volume pedal.
VOLUME "VOLUME"
Knob 5 LEVEL Adjust the minimum level for when the
pedal is in the full back position.
Pedal wah, Traveler, Talking pedal
These are wah (filter) effects that use the pedal to control the
frequency response.
If you use this effect in a program where the MODULA-
TION effect block is turned on, the MODULATION effect
block will automatically be turned off.
VOX WAH "WAH"
This simulates a vintage wah pedal. There are no adjustable
parameters. It is placed ahead of the DRIVE-AMP effect block.
TRAVELER "TRAVEL"
This is a low-pass filter type wah modeled after a vintage Korg
effect pedal.
Knob 1 ——— ————
Knob 2 FEEDBACK Adjusts the peak amount of the filter.
Knob 3 ——— ————
Knob 4 ——— ————
Knob 5 LEVEL Adjusts the output level.
TALK "TALK"
This adds vocal type effects to your guitar.
Knob 1 TOP Select the vowel sound produced when
the pedal is fully forward.
Knob 2 CENTER Select the vowel sound produced when
the pedal is in the halfway position.
Knob 3 BOTTOM Select the vowel sound produced when
the pedal is fully backward.
* Vowel sounds — A, E, I, O, U
20
Knob 1 Knob 2
FEEDBACK/
TOP/TIME CENTER/REVERSE
—
—
— 0...10
A, E, I, O, U A, E, I, O, U
1...10 0...10
—
0...900[ms] 0...10
—
0[ms]...3[SEC] 0...10
0[ms]...3[SEC] 0...10
0.5...8[SEC] OFF, 1, 2...8, LP1, LP2
Knob 3
BOTTOM/SPEED/
PITCH/TONE
— —
— —
—
A, E, I, O, U
0.1...10
— —
–24...24[x100 CENT] –15...15[CENT]
— 1...10
1...10
1...10
—
Chorus/Flanger
This is a chorus/flanger effect that uses the pedal to control the
mix amount of the effect.
If you use this effect in a program where the MODULA-
TION effect block is on, the MODULATION effect block
will automatically be turned off.
CHORUS/FLANGER
Knob 1 TIME
Knob 2 FEEDBACK Adjusts amount of feedback
Knob 3 SPEED
Knob 4 DEPTH
U-Vibe
This simulates a vintage vibrato/rotary speaker simulator.
If you use this effect in a program where the MODULA-
TION effect block is on, the MODULATION effect block
will automatically be turned off.
U-VIBE "U-VIBE"
Knob 4 DEPTH
Knob 5 MODE
Knob 4 Knob 5
LEVEL/MIX/
DEPTH/FINE POLARITY
— 0...10
—
— 0...10
—
0...10
0...10 1, 2
0...10
—
— 0...10
— 0...10
— 0...10
"CH/FLAN"
Adjusts delay time.
(delay repeats).
Adjusts pitch modulation speed.
Adjusts pitch modulation depth.
Adjusts depth of the effect.
0: Mixes the original sound with the ef-
fected sound (Chorus mode)
1: Output only the effect sound
(Vibrato mode)
—
—
—
—