Setting The Noise Reduction And Program Levels; Modifying Program Names; Writing Programs - Korg Toneworks AX1500G Owner's Manual

Setting the noise reduction and
program levels
1. If you are in Play mode, press the NR-PRG LEVEL
switch.
2. By rotating value knobs 1 or 2, or pressing the NR-
PRG LEVEL switch, you can access the screen
displays for adjusting the noise reduction and
setting the level for each program.
3. To adjust the amount of noise reduction, use value
knob 1 (range OFF...10: shown in the MASTER/
VALUE display).
4. To adjust the level of each program, use value knob
2 (range 0...10: shown in the MASTER/VALUE
display).
Noise reduction Level
Instead of value knobs 1 and 2, you can also use the
cursor switches ( , ) to select a parameter and use
the MASTER/VALUE switches to adjust the value of the
parameter.
Depending on the guitar that you use, raising the noise
reduction setting too high may cause the sound to be cut
off at low levels.
The volume of each program will change depending on
the guitar that you use. Adjust the program level for your
guitar.
If you wish to save the noise reduction and program level
settings that you edited, you must perform the "Program
write" operation. If you turn off the power or select a
different program without writing the program, the
program you modified will revert to its previous settings.

Modifying program names

Press the RENAME switch and specify the program
name (maximum 7 characters). Use the cursor switches
( , ) to select the character that you wish to change
(the character will blink). Then use value knob 5 to
select the desired character. The available characters
are shown below.
You can also use the MASTER/VALUE switches to
change the character.
If you wish to save the modified program name, you must
perform the "Program write" operation. If you turn off the
power or select a different program without writing the
program, the program name you edited will revert to its
previous setting.

Writing programs

Here's how to write an edited program.
1. Press the WRITE switch, and the name display will
indicate " WRITE ." The bank number display
and the program LED will blink.
2. Use the MASTER/VALUE switches ( , ) to select
the writing destination bank, and use the cursor
switches ( , ) to select the writing destination
program.
3. Press the WRITE switch once again, and the
display will read "COMPLT" to indicate that the
program has been written. You will then return to
Play mode.
You can also use value knob 5 or the bank switches to
select the bank, and the program switches to select the
program.
If you decide not to write, press the EXIT switch to
cancel the Write operation.
If you write an edited program to a different program
number, the program that was overwritten will be lost.
It is not possible to write to a preset program.
13