Wall-Mounting A 2-Slot Carrier And Modules - Lucent Technologies PARTNER Advanced Communications System Installation Manual

3
A) Label the line and extension jacks as shown.
B) If you are installing a two-module system,
continue with
and
Batteries in the PARTNER ACS Processor
Module''.

Wall-Mounting a 2-Slot Carrier and Modules

To wall-mount a 2-Slot Carrier, first follow the instructions in
Processor Module''.
NOTE:
To add a 308EC module to a PARTNER ACS module,
the ACS processor module must already be mounted
on the wall. If it is not, refer to
Standalone PARTNER ACS Processor Module''
the previous page for instructions. Before starting,
disconnect the power cord from the power jack on the
carrier. Then follow the instructions below.
You can install a 206, 308EC, 400, or PARTNER MAIL VS module as
the second module, using the following steps:
1
Remove the clear, plastic protector from the connector
on the right side of the new 308EC module by
grasping the tabs on the ends of the protector and
lifting. If you are upgrading from a standalone system,
also remove the protector from the wall-mounted ACS
processor module.
2
A) Remove the #8 sheet metal screw from the
bottom of the wall-mounted module or modules.
B) If you are upgrading an existing single module
system, skip to Step 4B.
3
If you are replacing the second module in a two-slot
carrier, remove the two #4 screws holding the carrier
in place, and gently pull the carrier off the modules.
''Wall-Mounting a 2-Slot Carrier
Modules''; otherwise, skip to
''Wall-Mounting a
''Inserting
''Wall-Mounting a Standalone PARTNER ACS
on
Mounting
Tracks
1
Lines
2
3
10
11
12
Extensions 13
14
15
16
17
Tab
Tab
Installation Procedures
11