Lucent Technologies MERLIN Plus Release 2 System Manual page 62

THE BIS-34, BIS-34D, OR
34-BUTTON DELUXE
VOICE TERMINAL USED
AS AN ADMINISTRATOR
CONSOLE
THE BIS-22 OR BIS-22D
VOICE TERMINAL USED
AS AN ADMINISTRATOR
CONSOLE
3-6 Administration Preview
If you are using a BIS-34, BIS-34D, or 34-Button deluxe voice terminal as the
administrator/attendant console, you have the ideal arrangement for your
MERLIN Plus system. You can administer all the features, including
Disallowed and Allowed Lists, Busy Buster, and Group Page, for all the voice
terminals on your system by using the Auto Intercom buttons (intercom numbers
10 through 29.) The lights next to each button indicate the status of the voice
terminal as you administer each feature. The administrator console is
automatically assigned the following features when you initially set up your
MERLIN Plus system:
Lines are assigned to 4 of the 10 buttons above the dial pad if the control unit
has one line module.
Lines are assigned to 8 of the 10 buttons above the dial pad if the control unit
has two line modules.
Auto Intercom buttons for intercom numbers 10 through 19 are assigned to
the top 10 buttons in the first-column of buttons to the right of the dial pad.
Auto Intercom buttons for intercom numbers 20 through 29 are assigned to
the top 10 buttons in the second column of buttons to the right of the dial pad.
If you are using a BIS-22 or BIS-22D voice terminal as the
administrator/attendant console, the voice terminal is automatically y assigned the
following features when you initially set up the MERLIN Plus system:
Lines are assigned to 4 of the 10 buttons above the dial pad if the control unit
has one line module.
Lines are assigned to 8 of the 10 buttons above the dial pad if the control unit
has two line modules.
Auto Intercom buttons for intercom numbers 10 through 19 are assigned to
the top 10 buttons in the column of buttons to the right of the dial pad.
If your system has more than 10 voice terminals (intercom numbers
20 through 29), you will not have buttons at the console for these voice
terminals. Therefore, when you administer Group Page, Program Mode
Lock, or program the Allowed and Disallowed Lists, you need to dial a code
from the Dial Code Chart that corresponds with the voice terminal. When
using the dial codes, you do not touch an Auto Intercom button.
Dial codes are not the same as intercom numbers.
If the Intercom
number k:
Intercom 20
Intercom 21
Intercom 22
Intercom 23
Intercom 24
Dial Code Chart
Dial this If the intercom
code: number is:
#03
Intercom 25
#04 Intercom 26
#05 Intercom 27
#06 Intercom 28
#07 Intercom 29
Dial this
code:
#08
#09
#10
#11
#12