Programming The System; Upgrading The System - Lucent Technologies MERLIN LEGEND Release 6.1 Installation Manual

MERLIN LEGEND Communications System Release 6.1
Installation 555-661-140
Introduction

Programming the System

Form 2c, System Numbering: Line/Trunk Jacks
Form 3a, Incoming Trunks: Remote Access
Form 3b, Incoming Trunks: DS1 Connectivity (100D Module)
Form 3d, Incoming Trunks: DID
Connecting Data Equipment
The following forms indicate the data equipment you will need to set up
data stations.
Data Form 1a, Modem Data Station
Data Form1b, 7500B Data Station
Data Form 2, Data Hunt Groups
Programming the System
If you have a system programming disk created with SPM or a
Translation memory card, you do not need to program the system.
Instead, you can use the disk or memory card to restore the system; see
Chapter 7, "Initializing and Testing the System," for instructions. If you
did not receive a disk or a memory card and it is your responsibility to
program the system, see System Programming for instructions.

Upgrading the System

If you are upgrading to Release 6.1 from Release 6.0, 5.0, 4.2, 4.1, 3.1,
3.0, 2.1, 2.0, 1.0, 1.1, or from the MERLIN
refer to Chapter 9, "Upgrading the System," then Chapter 7, "Initializing
and Testing the System," for upgrade instructions.
®
II Communications System,
Issue 1
August 1998
Page 1-4