Figure 2-10. Replacing A Ring Generator - AT&T MERLIN LEGEND Release 2.0 Installation Section

Installing the Control Unit
Steps a through e:
Open the power supply
Step f:
Detach cable
from wire clip
Step g:
Disconnect the P202 header
(pry the clip away from the header
and pull the header straight up)

Figure 2-10. Replacing a Ring Generator

f. Detach the cables from the inside edge of the plastic housing by
removing them from the clips.
2-34
Installing the Power Supply
P 2
WIRE
CLIP
RING GENERATOR
P 2 0 2
Step i:
Remove the four screws
(one in each corner of
the ring generator)
P 1
Step f:
Detach cable
from wire clip
Grip here
Grip here
P101
Step h:
Disconnect the
P101 header
(grip the sides and
pull forcefully)
Step t:
Wire manager:
make sure the
modification label is
attached when finished;
"Equipped with 129B
Freq Gen"