Programming The Heating In 5/2 Day Mode - Danfoss FP975 User Manual

Please Note
The unit must be programmed in sequence and ON/OFF times
cannot be set out of sequence.
If you want to leave a preset time as it is, simply press NEXT ON/
OFF to move on to the next setting.
Your timeswitch allows you to programme 3 ON and 3 OFF times
each day. If you do not wish to use one of the ON/OFF settings,
simply programme the ON time to be the same as the OFF time
and the setting will not operate.
!
If at any time you get confused and need to reset your timings
to the standard programme, press the RESET button to return
to the preset programmes (see page 7).

1.7.1 Programming the heating in 5/2 day mode

1. Press PROG until SET CH ON
TIME appears at the top of the
display and MOTUWETHFR
appears at the bottom of the
display.
Use the + and - buttons to set
the time you would like your
heating to fi rst come on in the
morning (Event 1).
2. Press NEXT ON/OFF once only.
Use the + and - buttons to set
the time you want your heating
to go off (Event 2).
To move to the next setting,
i.e. when you would like your
heating to come on again
(Event 3) press the NEXT ON/
OFF button again.
Danfoss Heating
GB
9