Gigabyte GA-P55A-UD3P User Manual page 86

B. Configuring SATA controller mode in BIOS Setup
Make sure to configure the SATA controller mode correctly in system BIOS Setup.
Step 1:
Turn on your computer and press <Delete> to enter BIOS Setup during the POST (Power-On Self-Test). To
create RAID, set PCH SATA Control Mode under the Integrated Peripherals menu to RAID(XHD) (Figure 1)
(IDE by default). If you do not want to create RAID, set this item to IDE or AHCI.
eXtreme Hard Drive (XHD)
PCH SATA Control Mode
SATA Port0-3 Native Mode
USB Controllers
USB Legacy Function
USB Storage Function
Turbo SATA3/USB 3.0
Azalia Codec
Onboard H/W LAN
Green LAN
 SMART LAN
Onboard LAN Boot ROM
Onboard IDE Controller
eSATA Controller
eSATA Ctrl Mode
GSATA Controller
GSATA Ctrl Mode
Onboard Serial Port 1
Onboard Parallel Port
higf : Move Enter: Select
F5: Previous Values
Step 2:
Save changes and exit BIOS Setup.
The BIOS Setup menus described in this section may differ from the exact settings for your moth-
erboard. The actual BIOS Setup menu options you will see shall depend on the motherboard you
have and the BIOS version.
Appendix
CMOS Setup Utility-Copyright (C) 1984-2010 Award Software
Integrated Peripherals
+/-/PU/PD: Value
F6: Fail-Safe Defaults
[Disabled]
[RAID(XHD)]
[Enabled]
[Enabled]
[Enabled]
[Enabled]
[Disabled]
[Auto]
[Enabled]
[Disabled]
[Press Enter]
[Disabled]
[Enabled]
[Enabled]
[IDE]
[Enabled]
[IDE]
[3F8/IRQ4]
[378/IRQ7]
F10: Save
Figure 1
- 86 -
Item Help
Menu Level 
ESC: Exit F1: General Help
F7: Optimized Defaults