Setup; Ac Power; Mounting; Orientation - Chauvet Obey 40 User Manual

3. S
ETUP

AC Power

Mounting

Orientation

Installation

Fixture Addressing

F
IXTURE
1
2
3
4
8

3. Setup

This fixture requires an external power supply, which is included. The included power supply is rated
for 100~240 VAC, 50/60 Hz, 500 mA max. Before powering on the unit, make sure the line voltage
to which you are connecting it is within the range of accepted voltages.
To determine the power requirements for a particular fixture, see the label affixed to the back plate
of the fixture or refer to the fixture's specifications chart. A fixture's listed current rating indicates its
average current draw under normal conditions.
Always connect the fixture to a switched circuit. Never connect the fixture to a rheostat
(variable resistor) or dimmer circuit, even if the rheostat or dimmer channel is used only as a
0 to 100% switch.
The Obey™ 40 may be mounted in any safe position.
Please see the drawing below, which shows the back of the controller. It details the dimensions for
mounting. This will aid in placing the holes for installation.
The Obey™ 40 can control up to 12 separate fixtures. Each fixture must be set to predetermined
DMX addresses. Please see the chart below for the DMX starting addresses of each of the twelve
fixtures.
DIP
A F
DDRESS SWITCH IXTURE
1 1
17 1,5
33 1,6
49 1,5,6
DIP
A
DDRESS SWITCH
5 65 1,7
6 81 1,5,7
7 97 1,6,7
8 113 1,5,6,7
9
F A DIP
IXTURE DDRESS
9 129 1,8
10 145 1,5,8
11 161 1,6,8
12 177 1,5,6,8
11/5/2010 10:15 AM
SWITCH