Engine Parameter Display Two engine operating parameter screens are provided.
Program Menus
The programming menu is used to change values such as time delays, analog fault settings,
digital fault settings. Access to the programming sub–menus may only be obtained with a
security password number. The sub menus are organized as follows:
The values of the parameter settings for your generator–set can be recorded for future reference
using the Configuration Data Sheet shown in Figure 4-4.
After the correct password number is entered, the you may choose one of four programming
menus. Press INCREMENT or DECREMENT to find the desired menu then press ENTER.
4-12 Operation
BATTERY
27.0 Vdc
SPEED
1800 rpm
ENG TEMP
57 Deg C
OIL PRESS
200 KPA
PROGRAM MENU?
NO
PASSWORD
0
MAIN MENU LOOP
ANALOG FAULT MENU LOOP
DIGITAL FAULT MENU LOOP
CALIBRATION MENU LOOP
MN2408