Section 4
Operation
Operator Control Panel (Digital Engine Controller Only)
The Operator Control Panel is shown in Figure 4-1.
WARNING: Never connect this generator to any buildings electrical system unless a licensed electrician
has installed an approved transfer switch. The National Electrical Code (NEC) requires that
connection of a generator to any electrical circuit normally powered by means of an electric
utility must be connected by means of approved transfer switch equipment so as to isolate
the electrical circuit from the utility distribution system when the generator is operating.
Failure to isolate the electrical circuits by such means may result in injury or death to utility
power workers due to backfeed of electrical energy onto the utility lines.
ALARM
SHUTDOWN
←
↓
↑
→
MN2408
Figure 4-1 Digital Operator Control Panel
MICROPROCESSOR ENGINE CONTROLLER
Vavg
Aavg
000
000
SILENCE
LAMP TEST
EXIT
DECREMENT
INCREMENT
RUN
OFF
READY
Freq
000
SPEED SIGNAL
RESET
ENTER
LOAD
AUTO
TEST
–
+
VOLTAGE
ADJUST
Operation 4-1