Manually Configuring Network Settings - Belkin G+MIMO User Manual

ManUally COnfIGURInG neTWORK seTTInGs

sections
table of contents
Set up the computer that is connected to the cable or DSL modem FIRST using these steps� You can also use these steps to add computers to your
Router after the Router has been set up to connect to the Internet�
Manually Configuring Network Settings in Mac OS up to 9.x
1� Pull down the Apple menu� Select "Control Panels" and select
"TCP/IP"�
2� You will see the TCP/IP control panel� Select "Ethernet Built-In" or
"Ethernet" in the "Connect via:" drop-down menu (1)�
3� Next to "Configure" (2), if
"Manually" is selected, your
Router will need to be set
up for a static IP connection
type� Write the address
information in the table
below� You will need to enter
this information into the
Router�
G+ MIMO Wireless Modem Router
1 2 3
(1)
(2)
4 5 6
4� If not already set, at "Configure:", choose "Using DHCP Server"�
This will tell the computer to obtain an IP address from the Router�
5�
Close the window� If you
made any changes, the
following window will
appear� Click "Save"�
Restart the computer� When the computer restarts, your network
settings are now configured for use with the Router�
71
7 8 9 10