Integrated Peripherals - ECS 945GCD-M Manual

Integrated Peripherals

This page sets up some parameters for peripheral devices connected to the system.
CMOS Setup Utility - Copyright (C) 1985-2005, American Megatrends, Inc.
Onboard IDE Controller
Onboard SATA Mode
Onboard AUDIO Function
Onboard LAN Function
Onboard LAN Boot ROM
Serial Port1 Address
Parallel Port Address
Parallel Port Mode
Parallel Port IRQ
USB Functions
Legacy USB Support
: Move
F1: General Help
Onboard IDE Controller (Both)
Use this item to enable or disable the onboard IDE interface.
Onboard SATA Mode (Enhanced)
Use this item to select the mode of the Serial ATA.
Onboard AUDIO Function (Enabled)
Use this item to enable or disable the onboard Audio function.
Onboard LAN Function (Enabled)
Use this item to enable or disable the onboard LAN function.
Onboard LAN BOOT ROM (Disabled)
Use this item to enable or disable the booting from the onboard LAN or a network
add-in card with a remote boot ROM installed.
Serial Port1 Address (3F8/IRQ4)
Use this item to enable or disable the onboard COM1/2 serial port, and to assign a
port address.
Parallel Port Address (378)
Use this item to enable or disable the onboard Parallel port, and to assign a port
address.
Parallel Port Mode (Normal)
Use this item to select the parallel port mode. You can select Normal (Standard
Parallel Port), ECP (Extended Capabilities Port), EPP (Enhanced Parallel Port), or
BPP (Bi-Directional Parallel Port).
Parallel Port IRQ (IRQ7)
Use this item to assign IRQ to the parallel port.
Integrated Peripherals
Both
Enhanced
Enabled
DISABLED: disables the
Enabled
integrated IDE
Disabled
Controller.
3F8/IRQ4
ENABLED: enables both
378
Controllers.
Normal
IRQ7
Enabled
Enabled
Enter : Select
+/-/: Value F10: Save ESC: Exit
F9: Optimized Defaults
Using BIOS
33
Help Item